Rubber and plastic seals come in a wide variety of shapes and types, designed to accommodate different installation methods and sealing requirements. Common types include:
1. O-rings: One of the most classic and widely used types. Featuring a circular cross-section, they are simple in structure and easy to install. They are suitable for static sealing, as well as dynamic sealing in applications involving low-speed reciprocating or rotary motion. Their sealing performance relies primarily on the initial contact pressure generated by pre-compression during installation; under the influence of fluid pressure, they undergo further deformation, which enhances the seal.
2. Oil seals (rotary shaft lip seals): Specifically designed for sealing rotating shafts, these prevent lubricating oil from leaking out through gaps in mechanical components while simultaneously keeping external dust and debris from entering. They typically consist of a metal casing and a rubber lip; the lip presses firmly against the shaft surface, achieving a seal through its own elasticity and, in many cases, the clamping force of an integrated garter spring.
3. Gaskets: Primarily used for sealing static mating surfaces, such as those found in pipe flanges or equipment housing covers. They come in various shapes-including flat and custom-contoured designs-and are available in a wide range of materials, which must be selected based on the specific medium, temperature, and pressure conditions.
4. Composite seals: To meet more demanding operating conditions (such as high pressure, high speed, or requirements for a long service life), seals are often constructed by combining components made from different materials. Examples include "step seals" (S-rings) and "glyd rings," which typically consist of a wear-resistant ring (often made of a plastic like PTFE) paired with a rubber elastomer. These combinations offer the dual benefits of low friction and excellent sealing performance.
5. Special-shaped seals: These include Y-rings, U-rings, and V-rings, which are frequently used for sealing reciprocating piston rods or pistons. Their lip-based geometry allows them to conform more effectively to the sealing surface when subjected to pressure.
