High Pressure Oil Line Sealing Washer covers two commonly used types: bonded washers and copper washers. High-pressure hydraulic line fittings typically use rubber-metal bonded washers, while high-pressure diesel fuel lines commonly use copper washers. Selection depends on the medium, pressure, and temperature. Bonded washers seal through rubber elasticity, while copper washers seal through the plastic deformation of copper.

Where Each Washer Belongs

A bonded washer consists of a metal skeleton vulcanized to a rubber layer. The metal carries the load, while the rubber provides the seal. This structure suits static end-face sealing at hydraulic line fittings and offers good vibration resistance with low leakage risk. The copper washer is made from annealed T2 pure copper with a hardness of HB≤45. It conforms to the sealing face through plastic deformation and is rated for pressures up to 60 MPa (600 bar), making it common in high-pressure diesel fuel lines. Bonded washers are available in self-centering and ordinary metric types. The self-centering type eliminates the need for a locating step, while the ordinary metric type follows JB982-77. Copper washers typically operate from -40°C to +300°C, with short-term peaks up to 400°C, making them suitable for higher-temperature applications where rubber sealing layers may be unsuitable.
For static end-face sealing at high-pressure hydraulic line fittings, rubber-metal bonded washers are generally the first choice because of their vibration resistance and ease of alignment during assembly. Copper washers are commonly used in high-pressure diesel fuel lines exposed to pressure and heat. They can also be used at high-temperature fittings carrying water, steam, or compressed air. Copper is unsuitable for concentrated acids, ammonia water, and sulfur-containing media that may cause corrosion. Bonded washers with rubber layers are unsuitable for concentrated strong acids, strong oxidizers, and ketone solvents. For bonded washers, NBR suits mineral hydraulic oil, engine oil, diesel, and grease; FKM is intended for high-temperature oil and fuel; and HNBR suits high-temperature hydraulic oil containing additives.

Ordering Both Types Together

Both types can be made to customer drawings or samples, with an MOQ of 500–1,000 pcs depending on material. Samples are available before bulk production. Pre-sales support reviews the line medium, pressure, and temperature to recommend a bonded or copper washer, followed by material advice and a quotation. All products undergo 100% inspection before packing, and third-party inspection is accepted. Incoming specification and appearance checks are covered within 30 days of receipt. These sealing washers are consumable parts, and no fixed service life is specified. Standard payment terms are 30% deposit and 70% before shipment. In-stock items ship within 3–5 days, out-of-stock items within 7–12 days, and special-material orders or peak-season orders within 12–15 days. Export packing uses PE bags and cartons with marks as requested; wooden or fumigation-free pallets are available for volume orders.
Product Specifications
|
Parameter |
Specification |
|
Product type |
Rubber-metal bonded washer, copper washer |
|
Bonded structure |
Metal skeleton + vulcanized rubber; semi- or fully rubber-covered; self-centering or ordinary metric |
|
Bonded pressure |
Rated pressure ≤40 MPa; short-term peak up to 60 MPa; static vacuum sealing |
|
Copper material |
T2 copper (pure copper, annealed, HB≤45) |
|
Copper pressure |
Maximum 60 MPa (600 bar) |
|
Copper temperature |
Normal range: -40°C to +300°C; short-term peak up to 400°C |
Hot Tags: high pressure oil line sealing washer, China high pressure oil line sealing washer manufacturers, suppliers, factory, High Pressure Oil Line Sealing Washer, Hydraulic Bonded Seal, Hydraulic Motor Shaft Seals, Hydraulic Piston Oil Seals, O Ring Hydraulic Cylinder, oil line seal
